1. First, remove the upper receiver from the lower receiver. You will need to unscrew the takedown pins to do this.
2. Next, take off the handguards. To do this, you will need to remove the gas tube first.
3. Once the handguards are off, locate the old gas block and remove it. Depending on your model of AR-15, there may be different ways of doing this ( Carroll 47).
4. Take your new low-profile gas block and line it up with the holes on the barrel. If everything lines up, then you can start screws into place ( stainless 5/32 set screws are recommended).
5. Once the screws are tight, you can put the handguards back on and reattach the gas tube.
6. Finally, screw the upper receiver back onto the lower receiver.
If you have any questions or concerns, please consult a professional gunsmith or firearms specialist.
There are a few different ways to install a low-profile gas block on an AR-15. The most common way is to use set screws, but there are also clamp-on and weld-on options available.
1. Set screw method: This is the most common way to install a low-profile gas block. You will need to remove the delta ring assembly, handguard cap, and front sight base to access the gas tube. Once you have gained access, simply unscrew the old gas block and screw on the new one. Be sure to tighten down all set screws securely.
2. Clamp-on method: This method is similar to the set screw method, but you will not need to remove the delta ring assembly or handguard cap. Simply unscrew the old gas block and screw on the new one. Be sure to tighten down all set screws securely.
3. Weld-on method: This is the most permanent way to install a low profile gas block. You will need to remove the delta ring assembly, handguard cap, and front sight base to access the gas tube. Once you have gained access, unscrew the old gas block and align the new one in its place. Tack weld the gas block in place and then finish welding all around it. Be sure to let the welds cool completely before using the firearm.
We also recommend checking the best weapon parts that will improve your AR-15.
If you are using set screws to install the gas block, start by threading them into place and then tightening them down with a wrench until they are snug. You don’t want to over-tighten them, as this can strip the threads or damage the gas block. Once the set screws are in place, you can install the gas tube. Start by threading it into the gas block and then hand-tightening it until it is snug. You don’t want to over-tighten the gas tube, as this can damage it.
Finally, once the gas tube is installed, you can install the handguard. Start by threading the handguard onto the barrel and then tightening it down with a wrench. Make sure that the handguard is properly aligned with the gas block before tightening it down too much, as this can cause problems later on. Once the handguard is installed, you’re all done!
Installing a low-profile gas block on an AR-15 is a relatively simple process that can be completed in just a few minutes. First, remove the old gas block by removing the two screws that hold it in place. Next, slide the new gas block into place and secure it using the same two screws. Finally, reattach the gas tube and test fire the weapon to ensure proper function.
The second way is to use a handguard cap removal tool. This will enable you to remove the handguard so that you can access the gas block without having to disassemble the rifle. Once you have removed the handguard, you can simply unscrew the old gas block and screw in the new one.
Finally, if you do not have either of these tools, you can still install the gas block by using two small Allen wrenches. Simply insert the wrenches into the set screws on the gas block and turn them in opposite directions until the gas block is loose. Then, remove the old gas block and screw in the new one. Remember to torque the set screws to the proper specification so that the gas block is securely installed.
Please login or Register to submit your answer